Mitsubishi 3000GT Service Manual page 836

SERVICE BRAKES
After a test drive*, use on-board diag-
No diagnostic trouble codes output and
normal codes are displayed?
Yes
All ABS functions are normal. (Nor are
there stored memory of past diagnostic
trouble code.)
Connector terminal No. layout for
troubleshooting
Terminal No. layout shown on the
special tool connector
NOTE
l :
Drive at 19 mph or higher
for more than 30 seconds.
.
Caution
1. When carrying out inspection of the ABS-ECU terminal
voltage and resistance, the special tool (MB991356)
should be used.
2. Because the ABS-ECU connector terminal No. layout
for troubleshooting is different from the terminal No.
layout shown on the special tool connector, when
using the special tool for inspecting, take the readings
from the special tool terminal Nos.
Example
ABS-ECU connector terminal
No. for troubleshooting
18
on-board diagnostic output ter-
minals and the diagnosis check
intermittent or other trouble.
watch vehicle movements until
it reappears. (Refer to P.35-11.)
Terminal No. shown on the spe-
1
I