Mitsubishi 3000GT Service Manual page 199

MULTIPORT
On-Vehicle Inspection of MFI
FUEL INJECTION - Components
SENSOR INSPECTION
(1) Remove engine coolant temperature sensor from the in-
take manifold.
(2) With temperature sensing portion of engine coolant tem-
perature sensor immersed in hot water, check resistance.
Temperature "C (OF)
(3) If the resistance deviates from the standard value greatly,
replace the sensor.
INSTALLATION
(1) Apply sealant to threaded portion.
Specified sealant:
(2) Install engine coolant temperature sensor and tighten
it to specified torque.
Sensor tightening torque: 30 Nm (22 ft.lbs.)
(3) Fasten harness connectors securely.
TSB Revision
20 (68)
40 (104)
80 (176)
3M NUT locking Part No. 4171 or equivalent
Resistance (Wz)
5 . 6
2.4
1.1
0.3