Mitsubishi 3000GT Service Manual page 956

MB99
MB991 354
bolt
PARKING BRAKES
REMOVAL SERVICE POINTS
Caution
When removing the speed sensor from the knuckle, use
care not to hit the pole piece at its tip against the rotor
teeth or other parts.
With the special tool, secure the axle shaft and remove the
companion flange self-locking nut.
With the special tool, remove the axle shaft from the trailing
arm.
INSTALLATION SERVICE POINTS
I
The shoe-to-anchor spring must be installed in the sequence
shown in the illustration.
Caution
Each shoe-to-anchor spring has a unique spring load
and the spring "a" is painted to prevent erroneous
installation.
NOTE
The figure shows the left wheel; for the right wheel, the position
in symmetrical.
Install the adjuster facing the left adjusting bolt to the vehicle
front and right adjusting bolt to the vehicle rear.