Mitsubishi 3000GT Service Manual page 687

Dust seal inner
Dust seal outer .
FRONT AXLE - Drive Shaft
(1) Apply multipurpose grease to the center bearing and
inside the center bearing bracket.
(2) Use the special tools to press-fit the center bearing into
the center bearing bracket.
(1) Apply multipurpose grease to the rear surfaces of all dust
seals.
Dust seal inner: 14-20 g (.49-.71 oz.)
Dust seal outer: 8-12 g (.28-.42 oz.)
(2) Press the oil seal into the center bearing bracket using
the special tool.
MB990890
Caution
Take care not to damage the rubber part on the
periphery of the dust seal.
(3) Apply multipurpose grease to the lip of each dust seal.
NOTE
When applying grease, make sure that it does not adhere
to anything outside the lip.