Optimizing Printing Or Cutting To Match Media Thickness; Adjusting Head Height To Match Media Thickness (54-Inch Model Only) - Roland VersaCamm VP-540i User Manual

4-4 Optimizing Printing or Cutting to Match Media Thickness

Adjusting Head Height to Match Media Thickness (54-inch Model Only)

Procedure

MENU
HEAD HEIGHT

HEAD HEIGHT
LOW


MENU
4 HEAD HEIGHT

W1200mm
SETUP SHEET
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the chance of contact
with the print heads. When you are using such media, adjust the head height to "HIGH." (On the 30-inch model, the head
height cannot be changed.)
Printing quality when the head height is set to "HIGH" may be coarser or otherwise lower than when set to "LOW. " If this hap-
pens, refer to the pages indicated below.
 P. 73 "Correcting for Misalignment in Bidirectional Printing," p. 74, "Correcting for Misalignment in Bidirectional Printing More Precisely,"
p. 80, "Preventing Soiling of the Media and Dot Drop-out During Printing"
72
Press
Press
Press
LOW
High
Low (Standard)
Height-adjustment lever
Move firmly, until it stops.
Close the front cover.
The print-head carriage moves to the original position, and then the screen shown
in the figure appears.
Press
.
several times.
.
Open the front cover.
Move the height-adjustment lever to adjust
the head height.
to go back to the original screen.