2-1 Switching the Power On and Off
Switching the Power On and Off
This machine has a main power switch and a sub power switch. When using the machine, you switch both on in this sequence:
first the main power, then the sub power.
Whenever output is finished, switch off the sub power. Also, raise the loading lever.
Leave the main power switch
WARNING
2
Important Note on Switching Off the Power
Never switch off the main power or unplug the power cord suddenly while operation is in progress. Doing
so may damage the print heads. Be sure to first switch off the sub power.
If the main power is accidentally switched off, immediately turn the power back on.
30
on at all times, never switching it off.
When output is not being performed, remove any loaded media or switch off the
sub power.
The continued application of heat at a single location may cause the release of toxic
gases from the media or pose a fire hazard.
Turn this switch on after
Sub power switch
closing the front cover.
To turn it off, hold down
the switch for one sec-
ond or longer.
Main power switch
Be sure to leave
switched on at
all times.
Keep the loading lever raised when
the machine is not in use.