Table of Contents
Advertisement
2-2 Loading and Cutting Off Media
Make sure both edges of the media are above the grit rollers, then place pinch rollers over
all grit rollers covered by the media.
Placing the pinch rollers inside each of the grit patterns ensures that they are positioned above the grit rollers.
Be sure to place the left and right pinch rollers (affixed with blue stickers) at the edges of the media. Arrange the
middle pinch rollers above all the grit rollers that lie between the left and right pinch rollers.
Be sure to remove any extra middle pinch rollers, leaving only the same number of middle pinch rollers as the number
of grit rollers.
Left pinch roller
Affixed with a blue sticker.
2
Position this at
locations that is not
overly close to the
edge of the media.
Attaching and Detaching Middle Pinch Rollers
Perform attachment or detachment at the location shown in the figure.
Slide along the rail.
34
About
10 mm
Be sure to place the right edge of
the media on these grit rollers.
Insert all the way.
Place the pinch
roller inside the
grit pattern.
Grit pattern
About
10 mm
Attachment/
detachment location
Pull back and out.
Right pinch roller
Affixed with a blue
sticker.
Position this at
locations that is
not overly close
to the edge of
the media.
Advertisement
Table of Contents
