Accurately Adjusting The Cutting-In Amount; Preventing Pulling Of The Media With Undue Force When Performing Cutting Only - Roland VersaCamm VP-540i User Manual

Accurately Adjusting the Cutting-in Amount

Min. 0 mm
Amount of blade
extension
Rough Estimate for the Amount of Blade Extension
Use the following dimension as a rough estimate for setting the amount of blade extension.
Amount of blade Thickness of the
=
extension material portion

Preventing Pulling of the Media with Undue Force When Performing Cutting Only

Procedure

MENU
CUTTING MENU

CUTTING MENU
PREFEED

PREFEED
DISABLE ENABLE

W1200mm
SETUP SHEET
4-8 Making Various Adjustments for Cutting
When you want to perform accurate and fine adjustment
of the cutting-in amount, such as when cutting media
Max. 2.5 mm
with thin backing paper, you can obtain good results by
adjusting the tip of the blade.
Turn the cap portion of the blade holder to adjust the
amount of blade extension. Each indicator tick corre-
sponds to 0.1 millimeters, and adjustment for 0.5 milli-
meters can be made by rotating the cap one full turn.
Note that making the amount of blade extension too
small may cause the end of the cap for the blade holder
to touch and damage the printed surface. It's important
to be especially careful about this when you're using
media that has poor ink-adhesion properties.
Thickness of the
backing paper
+
2
Material
portion
Backing paper
portion
Press .
Press .
Press .
Press several times.
Press .
Use to select "ENABLE."
Press to enable the setting.
Press to go back to the original screen.
Blade holder
Half of the
backing paper
Amount of blade extension
is approximately equal to
Blade
the cutting-in amount.
4
91