Roland VersaCamm VP-540i User Manual page 100

3.
Print a test pattern and cut it.

MENU
CUTTING MENU

CUTTING MENU
CROP - CUT ADJ.

CROP - CUT ADJ.
TEST PRINT
Cutting position and printing
position are misaligned.
When adjustment is needed, go on to the steps below.
4.
Print and cut a test pattern for adjustment.
CROP - CUT ADJ.
TEST PRINT 2
5.
From the test pattern, read the correction value at the location.
Test pattern
Correction-value scale
Check the value on
the [FEED] side.
4-9 Performing Printing and Cutting Separately
Press .
Press .
Press .
Press .
Press .
Press .
Cutting
position
Printing
position
Cutting position and printing
position are aligned.
Press .
Press to execute.
Check the value on
the [SCAN] side.
Scan direction
Cutting line
Cutting
position
Printing
position
Cutting line
The point where the cutting line
intersects the correction-value
scale is the correction value. In this
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
4
99