Table of Contents
Advertisement
4-8 Making Various Adjustments for Cutting
Description
When you're performing cutting only, it may be convenient to set this feature to "ENABLE." This feeds out media according to
the size of the data sent from the computer before performing cutting. This makes it unnecessary to turn the media flanges
by hand to feed out media every time you perform cutting. Note, however, that this feeds out media even when you're
performing printing only, so set it to "DISABLE" when not needed.
Default Setting
[PREFEED]: DISABLE
Correcting Misalignment of the Printing and Cutting Positions
Procedure
1.
Check the setting for the [AUTO ENV. MATCH] menu item.
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
P. 84, "Executing Environment Matching Automatically"
2.
Execute the [ADJUST BI-DIR] menu item.
Load the media.
P. 32, "Loading Media"
P. 82, "How to Load Sheet Media"
4
Perform bidirectional adjustment.
P. 73, "Correcting for Misalignment in Bidirectional Printing"
P. 74, "Correcting for Misalignment in Bidirectional Printing More Precisely"
3.
Print a test pattern and cut it.
MENU
CUTTING MENU
CUTTING MENU
PRINT - CUT ADJ.
PRINT - CUT ADJ.
TEST PRINT
92
Press
.
Press
.
Press
.
Press
.
Press
.
The test pattern is printed at three locations: at the two edges and in the center.
When adjustment is needed, go on to the steps below.
Advertisement
Table of Contents
