Performing Distance Correction During Cutting - Roland VersaCamm VP-540i User Manual

Default Setting
[SETTING]: 0.00%

Performing Distance Correction During Cutting

Procedure

MENU
CUTTING MENU

CUTTING MENU
CALIBRATION

CALIBRATION
FEED SETTING

FEED SETTING
0.00% 0.00%

CALIBRATION
SCAN SETTING

SCAN SETTING
0.00% 0.00%

W1200mm
SETUP SHEET
Description
The movement distance of the media changes subtly depending on the media's thickness. This means that the length of a
line when cut may differ from the length setting in the data. You enter a correction value when you want to align the lengths
of cut lines precisely.
However, when you're performing printing followed by cutting, be sure to set the correction value to "0.00%. " Otherwise the
printing and cutting positions may become misaligned.
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
4-4 Optimizing Printing or Cutting to Match Media Thickness
Press .
Press .
Press .
Press several times.
Press .
Press .
Use to make the setting for the correction value.
Press to enable the setting for [FEED SETTING].
Press .
Press .
Press .
Use to make the setting for the correction value.
Press to enable the setting for [SCAN SETTING].
Press to go back to the original screen.
4
77