Table of Contents
Advertisement
4-9 Performing Printing and Cutting Separately
6.
Enter the correction value you read.
CROP - CUT ADJ.
SETTING
F :- 0.30
S : 0.00
CROP - CUT ADJ.
SETTING
7.
Check the results of adjustment.
CROP - CUT ADJ.
TEST PRINT
4
Description
Depending on the composition of the media, the positioning of printing and cutting may be misaligned even when you're
using crop marks. Make corrections for misaligned printing and cutting for the media you're using.
Default Setting
[F] (feed direction): 0.00 mm
[S] (scanning direction): 0.00 mm
100
Press
Press
- 0.30mm
Use
- 0.20mm
direction).
Use
direction).
Press
Press
Press
Press
Cutting position
Printing position
Cutting position and printing
position are aligned.
.
.
to set the correction value for [F] (the feed
to set the correction value for [S] (the scanning
to enable the setting.
.
.
to execute.
If the printing and cutting lines are aligned, adjustment is
complete.
If further adjustment is needed, go back to step
fine-tune the adjustment.
and
Advertisement
Table of Contents
