Table of Contents
Advertisement
2-2 Loading and Cutting Off Media
Loading Media
Media may be of one of two types: media wound onto a paper tube (called "roll media") and media not rolled in this way
(called "sheet media"). This section explains how to load media, using roll media as an example. For information on how to
load sheet media, refer to the page indicated below.
P. 82, "How to Load Sheet Media"
CAUTION
2
CAUTION
CAUTION
1.
Pass the media through the machine and position it correctly on the left and right.
Open the front cover.
Move the media clamps to the sides.
Attach the media flanges to the roll media.
If the inner diameter of the roll-media core measures 3 inches, fit the media flanges onto the core, then turn each
knob clockwise all the way to keep the media flanges from falling out.
Knob
32
Load roll media correctly.
Otherwise the media may fall and cause injury.
Roll media weighs about 30 kg (66 lb.). To avoid injury, handle with care.
Never load media that weighs more than 30 kg (66 lb.) (or, for the 30-inch model,
more than 20 kg (44 lb.)).
The machine may fail to withstand the weight and tip over or cause the media to
fall.
2 inches
Match to the inner
diameter of the roll-
media core.
Roll-media
Media clamps
3 inches
Press in to fit
on securely.
Turn until the knob
stops rotating.
Advertisement
Table of Contents
