Table of Contents
Advertisement
6-5 Specifications
*1
The length of printing or cutting is subject to the limitations of the program.
*2
○
With Roland PET film, print travel: 1 m
○
Temperature: 25°C (77°F), humidity: 50%
*3
Not assured when the print heater or dryer is used.
*4
The following conditions must be met:
○
Media type: Media specified by Roland DG Corp.
○
Roll media must be loaded on the shaft.
○
[PREFEED] menu item must be set to "ENABLE."
○
Side margins: 25 mm or more for both the left and right margins
○
Front margin: 35 mm or more
○
Excluding expansion/contraction of the media
Range for assured repetition accuracy
○
54-inch model
For media with a width exceeding 610 mm: Length 4,000 mm
For media with a width of 610 mm or less: Length 8,000 mm
○
30-inch model
Length 3,000 mm
*5
○
Provided that media length is under 3,000 mm
○
Temperature: 25°C (77°F)
○
Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*6
○
Media type : Roland PET film
○
Data size: 1,000 mm in the media-feed direction, 1,346 mm (54-inch model) or 736 mm (30-inch model) in the carriage-movement
direction
○
No lamination
○
Automatic detection of crop marks at 4 points when media is reloaded.
○
During cutting, [PREFEED] menu item must be set to "ENABLE."
○
Temperature: 25°C (77°F)
○
Excludes the effects of slanted movement and of expansion and contraction of the media.
*7
○
Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating environment.
○
Depending on the ambient temperature and media width, the preset temperature may fail to be reached.
*8
○
Depth when the included ink-cartridge tray is installed is 1,000 mm.
*9
Operating environment
6
132
Use in an operating envi-
ronment with this range.
Advertisement
Table of Contents
