Table of Contents
Advertisement
2-3 Settings for the Media Heating System
What Is the Media Heating System?
This machine is equipped with a media heating system that warms the media. You use this mainly, on ECO-SOL MAX ink
models, to improve ink adhesion and dry the ink. You can adjust the temperature settings to match the type of media and
the printing speed.
Note:
For AQUEOUS PIGMENT ink models, using the media heating system is normally not necessary. However, the
media heating system might be effectively used for some kind of media. Please use it after confirming the settings.
Print heater
This heater is used mainly to improve ink
adhesion.
Dryer
You use this to speed up drying of the ink.
WARNING
Caution: high temperatures
The platen and dryer become hot. Exercise caution to avoid fire or burns.
WARNING
Remove any loaded media or switch off the sub power when printing is not being
performed.
The continued application of heat at a single location may cause fire or produce
toxic gases.
WARNING
Never use media that cannot withstand the heat.
Doing so may result in fire or the release of toxic gases, or may degrade the me-
dia.
WARNING
Never use the platen or dryer for any purpose for which they are not intended,
such as to dry clothing.
Doing so may cause overheating, resulting in fire or accident.
Making the Temperature Setting for the Media Heating System
Procedure
FUNCTION
HEATER CONFIG
HEATER CONFIG
DRYER
34 C
Present dryer temperature
DRYER
35 C
40 C
W1200mm
SETUP SHEET
By default, simply switching on the power does not make the media heating system warm up to the preset temperature.
When media is loaded correctly and
Press
.
Press
several times.
Press
.
Use
to select [PRINT] (print heater) or [DRYER]
(dryer).
Press
.
Use
to make the setting.
Press
to enable the setting.
Press
to go back to the original screen.
comes on, warm-up to the preset temperature occurs.
2
39
Advertisement
Table of Contents
