Notes To Follow; Do Not Perform Operations That Pull The Media With Excessive Force; Turn Off The Automatic Cut-Off Function For The Media; Notes To Follow When "Tu" Is Selected - Roland TU4-64 User Manual

Notes to Follow

When using this machine, be sure to comply with the conditions shown below. Failure to do so may lead to
errors occurring, the output stopping at unexpected times, and the output work being obstructed.

Do Not Perform Operations That Pull the Media with Excessive Force

When this machine is used, a tension for taking up the media is applied, so it is necessary to avoid opera-
tions that pull the media with excessive force.
• Do not operate the MANUAL switch on the take-up unit leaving the loading lever pulled (lowered).
• Do not feed the media reversely by pressing the [▲] cursor key.

Turn Off the Automatic Cut-off Function for the Media

If the media is cut off, take-up will be interrupted at that point. If you use the software RIP or a similar
method to set the automatic cut-off function, take-up may be interrupted at an unexpected point. We rec-
ommend that you turn off the automatic cut-off function.

Notes to Follow When "TU" Is Selected

This section only applies to models that are equipped with a cutting function.
There are a number of notes to follow in order to ensure that the media is not pulled with excessive force
when "TU" is selected from the printer menu list. Failure to do so may lead to errors occurring, the output
stopping at unexpected times, and the output work being obstructed.
P. 4Selecting the Take-up Method
• Do not carry out output performed with cutting (cutting only, printing and cutting, and cropping and
cutting).
• When sending media forward with the [▼] cursor key, set the base point.
• Set the "PREFEED" menu item to "DISABLE".
• If there is the "FEED FOR DRY" menu item, set it to "DISABLE".

Notes to Follow When "TU3" Is Selected

• Do not carry out output performed with cutting (cutting only, printing and cutting, and cropping and
cutting).
• When media is sent forward with the [▼] cursor key, the base point is set automatically.
• Set the "PREFEED" menu item to "DISABLE".
• If there is the "FEED FOR DRY" menu item, set it to "DISABLE".
This section only applies to the case in which the TB-30 option is attached to the LEC2-330 or MG-300.
For details, see the TB-30 Setup Guide.
https://downloadcenter.rolanddg.com/TB-30
23
Operation