Table of Contents
Advertisement
Cutting position and printing
position are misaligned.
4.
Print and cut a test pattern for setting the correction values.
PRINT - CUT ADJ.
TEST PRINT 2
5.
From the test pattern, read the value at the location.
Test pattern
Correction-value scale
Check the value on
the [FEED] side.
6.
Enter the correction value you read.
PRINT - CUT ADJ.
SETTING
F :- 0.30
- 0.30mm
S : 0.00
- 0.20mm
PRINT - CUT ADJ.
SETTING
4-8 Making Various Adjustments for Cutting
Cutting
position
Printing
position
Cutting position and print-
ing position are aligned.
Press
.
Press
to execute.
Check the value on
the [SCAN] side.
Scan direction
Cutting line
Press
.
Press
.
Use
to set the correction value for [F] (the feed
direction).
Use
to set the correction value for [S] (the scanning
direction).
Press
to enable the setting.
Press
.
Cutting
position
Printing
position
Cutting line
The point where the cutting line
intersects the correction-value
scale is the correction value. In this
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
4
93
Advertisement
Table of Contents
