To Quit Detection and Start Cutting
CANCEL CROPMARK
DETECTION?
Press
.
This stops detection and starts cutting.
Note: After pressing
in step
P. 68, "Pausing or Canceling Output"
Aligning Manually and Cutting
Depending on the type of media, it may not be possible to detect crop marks automatically. When crop marks cannot be
detected automatically, you perform alignment manually.
Procedure
1.
Set the base point.
W1100mm
B
2.
Set the align points.
4-9 Performing Printing and Cutting Separately
Press
.
Crop-mark detection stops. Depending on the content of the data, some time may
pass before detection actually stops.
, resuming detection or canceling output is also possible.
Use
center of the blade with the location shown
in the figure.
Press
.
Press
.
Use
center of the blade with the location shown
in the figure.
to align the
4
to align the
97