Table of Contents
Advertisement
2-6 Performing Cutting
Hints and Tips for Cutting
Setting the [PREFEED] menu item to "ENABLE" makes the machine automatically feed out media and
take it up again before cutting. This makes it unnecessary to run out media to the rear of the machine
before the operation.
P. 91, "Preventing Pulling of the Media with Undue Force When Performing Cutting Only"
When you're performing cutting, switching off the print heater and dryer and allowing the temperature
to cool before performing cutting can yield results that are more stable.
P. 87, "Switching Off the Print Heater and Dryer"
2
The end of the cap for the blade holder may scrape or damage the printed surface. If this happens,
increase the amount of blade extension.
P. 91, "Accurately Adjusting the Cutting-in Amount"
Performing a Cutting Test
For high-quality cutting, then before you perform actual cutting, we recommend carrying out a cutting test to check the
cutting quality for the media.
Performing a Cutting Test
Use
to carry out the cutting test.
You can freely set the location for the cutting test.
FUNCTION
CUT CONFIG
CUT CONFIG
TEST CUT
Peel off the cut shapes to verify the cutting quality.
If two shapes peel off together, make the setting for blade force.
P. 47, "Making the Setting for Blade Force"
46
to move the cutting carriage to the location where you want
Press
.
Press
several times.
Press
.
Close the front cover.
Press
Rectangle
The test pattern is cut.
Circle
.
Advertisement
Table of Contents
