4-9 Performing Printing and Cutting Separately
Aligning Automatically and Cutting
When you make the setting for reading crop marks when sending cutting data from the computer, alignment is performed
with the presence or absence of crop marks determined automatically.
For information on how to make the setting, refer to the documentation for the software RIP you're using.
Procedure
4
Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
CROPMARK ERROR
Reload the media, then send the data again.
If this does not resolve the problem, then perform alignment manually.
P. 97, "Aligning Manually and Cutting"
If the crop marks cannot be detected easily because of the effects of media warping or the like, then perform alignment
manually. When you want to perform automatic alignment with lengthy media, we recommend performing output with the
data separated into sizes that are as short as possible. With large sizes, error due to warping and the like increases, making
smooth detection impossible.
96
Crop marks
Blade protection
If the machine fails to detect the crop marks, the screen shown in the figure appears
NOT FOUND
and operation stops.
If this happens, press
Load the media.
Angled no more than 5 degrees.
Otherwise alignment becomes impossible.
5 degrees
or more
5 degrees
or more
, then take action as follows.