Table of Contents
Advertisement
5-1 The Machine Doesn't Run
The Printer Unit Doesn't Run
Is the power switched on?
Switch on the printer's main power, then press the sub power
switch and make sure the sub power switch lights up.
Is
illuminated?
Output is not performed when
Lower the loading lever.
Is the front cover open?
Close the front cover.
Is the top menu displayed?
W1200mm
Top menu
P. 41, "Getting Ready to Receive Data from a Com-
puter"
Is
illuminated?
When
lights up, operation is paused. To resume, press
.
1
2
3
4
displayed, a message appears and a warning beep sounds. At the
same time, operation pauses. When the ink cartridge is replaced
with a new one, printing or cutting starts.
P. 44, "If Ink Runs Out"
P. 84, "Determining What Happens When Ink Runs Out"
Is a message displayed on the screen?
P. 122, "If a Message Appears"
P. 123, "If an Error Message Appears"
5
Is the cable connected?
Connect the cable securely.
Is the Link LED lighted?
If the Link LED for the Ethernet connector is not lighted, it means
that a correct connection to the network has not been made.
Make sure the network routing is suitable. Try connecting the
computer and the machine to the same hub, or connecting
them directly using a crossover cable. If this makes it possible to
perform output, it means the problem is in the network itself.
Are the network settings correct?
If output is not possible even though the Link LED is lighted,
check to make sure the IP address and other such settings are
correct. The settings on both the machine and the computer
must be appropriate. Redo the settings, checking to ensure that
the IP address doesn't conflict with the IP address for another
116
is not illuminated.
If the top menu isn't displayed,
output doesn't start even when
data is sent from the computer.
To go to the top menu, press
, then press
goes dark and outputting resumes.
Has ink run out?
When printing data is sent while
the screen shown in the figure is
device on the network, that the port setting for the software RIP
specifies the IP address set on the machine, that the settings have
no typing errors, and for other such problems.
Setup Guide
P. 104, "Viewing the Network Settings"
Did the software RIP end abnormally?
Make sure the software RIP is running correctly, then switch the
sub power switch off and back on.
The Media Heating System Doesn't Warm Up
Is media loaded?
The media heating system does not warm up to the preset
temperature when
and wait for the machine to warm up.
P. 87, "Determining How the Media Heating System
.
Operates"
Is the temperature of the room too low?
If the machine is an ECO-SOL MAX ink model, use it in an environ-
ment where the temperature is 20 to 32°C (68 to 90°F).
P. 40, "General Guide for the Preset Temperatures"
is dark (by default). Load media
Advertisement
Table of Contents
