Drying The Trailing Edge Of The Printing Area On The Dryer - Roland VersaCamm VP-540i User Manual

4-7 Changing the Ink-drying Method
Description
This feature controls the temperature of the media heating system automatically when
"MENU" performs heating to the preset temperature at all times, without lowering the temperature when
"30°C" lowers the temperature of the media heating system to a fixed temperature (30°C) when
"OFF" switches off the media heating system when
Default Setting
[PREHEATING]: 30°C

Drying the Trailing Edge of the Printing Area on the Dryer

Procedure

MENU
HEATER MENU

FEED FOR DRY
DISABLE

W1200mm
SETUP SHEET
4
Description
When this menu item is set to "ENABLE," additional media feed is performed until the trailing edge of the printing area is
positioned directly on the dryer.
The margin between the print-end position and the next print-start position is set to a value of 100 millimeters.
When a margin setting of less than 100 millimeters has been made on the computer, that setting is ignored and a margin
value of 100 millimeters is used.
However, when a margin setting of greater than 100 millimeters has been made on the computer, the computer's setting is
used for the margin value.
When this is set to "DISABLE," media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
88
Press
Press
Press
Use
ENABLE
Press
Press
is dark.
.
several times.
twice.
to select "ENABLE."
to enable the setting.
to go back to the original screen.
is dark.
is dark.
is dark.