System Alarm Setup; Table 2-18 Description Of Alarm - NEC SL1000 Programming Manual

ISSUE 1.0
Level
IN
Description
Use Program 90-10 : System Alarm Setup to assign a status to system alarms. You can designate
an alarm as Major or Minor. This program also assigns whether or not the alarm information is reported
to the pre-defined destination.
Input Data
Alarm Number
Item No.
01
02
Alarm Re-
Type Name
No. port
1 2 0 PKG Initial-
ize Error.
2 2 0 PKG
Mounting
Error
Programming Manual
Program 90 : Maintenance Program
Item
Alarm Type 0 = Not Set
1 = Major Alarm
2 = Minor Alarm
Report 0 = Not Report (No autodial)
1 = Report (autodial)

Table 2-18 Description of Alarm

Content of
Alarm
1 The PKG failed 1 PKG not in-
to initialize.
2 The PKG did 2 PKG was re-
not start nor-
mally.
3 Old PKG data
The unit did not 1 The package is
step on a regular
procedure and it
was pulled out. 2 The package is
Or, it is not normally
inserted.

90-10 : System Alarm Setup

001 ~ 100
Input Data
Cause Action
1 Insert PKG
serted firmly. firmly.
2 Insert PKG
moved, but not firmly.
reinserted 3 Delete slot in-
firmly. formation in
Program 90-05
still reported and insert the
due to no ini- PKG again.
tialization.
1 Please insert
not completely the package
inserted. firmly.
2 Please try again
out of order. after initializing
the system data
once when LED
doesn't blink
normally.
3 Exchange pack-
ages.
SL1000/SL1100
Program
90
Alarm
Recovery Status
During ini- ERR
tialization, REC
the PKG is
recognized.
When unit is ERR
reconfirmed, REC
the error is
recovered.
2-511