Service Tone Timers - NEC SL1000 Programming Manual

ISSUE 1.0
Level
IN
Description
Use Program 20-18 : Service Tone Timers to set the values for the system service tone timers. Refer
to the following chart for a description of each option, its range and default setting.
Input Data
Item
Item
No.
01 Extension Dial Tone Time
02 Busy Tone Timer
03 Congestion Tone
04 Call Waiting Tone Timer
05 Multiline Confirmation
Tone
06 Interval of Call Waiting
Tone
07 Intrusion Tone Repeat
Time
08 Conference Tone Interval
09 Warning Beep Tone Sig-
naling Interval
Conditions
None
Feature Cross Reference
• Distinctive Ringing, Tones, and Flash Patterns
Programming Manual
Program 20 : System Option Setup
Input Data Default
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds

20-18 : Service Tone Timers

Description
30 After getting Intercom dial
tone, a telephone user has
this time to dial the first
digit of the Intercom call.
15
10 A Busy Tone when system
resources run short. (Such
as DTMF receiver re-
sources).
10 This option sets the time
between Call Waiting
tones. This timer also sets
the time between Off-Hook
Signaling alerts.
10
10
0 After a call is interrupted
(such as Barge-In, Voice
Mail Conversation Record-
ing, or Voice Over), the
system repeats the Intru-
sion Tone after this time.
Normally, you should enter
0 to disable this time.
0
60
SL1000/SL1100
Program
20
Related Pro-
gram
14-01-18
2-187