NEC SL1000 Programming Manual page 240

SL1000/SL1100
Item No.
10 Dial Digits for Toll Restriction
Path
If this option is programmed with
an entry other than 0, a call does
not have a talk path unless the
user dials at least the number of
digits entered in this option when
placing an outgoing call.
This means that an entry of 4 or
higher in this program causes a
problem when dialing 911 (USA
only). Since it is only a 3-digit num-
ber, the call does not have a talk
Program
path, preventing the emergency
dispatcher from hearing the caller.
This option should be kept at its
21
default setting of 0 to prevent any
problems with dialing 911 (USA
only).
11 Inter-Digit Time for Toll Restric-
tion Path Control
12 Dial E911 Routing Without Trunk
Access
If enabled (1), an extension user
can dial 911 (USA only) without
first dialing a trunk access code or
pressing a line key. If disabled (0),
an extension user must dial a trunk
access code (e.g., 9) or press a
line key before dialing 911 (USA
only).
13 Alarm Ring Timer (E911)
Use this option to set the duration
of the E911 Alarm Ring Time. If set
for 0, the E911 Alarm does not
ring.
14 Forced Account Code Inter-digit
Timer
The system waits this time for a
user to enter a Forced Account
code.
15 Outgoing Disable on Incoming
Line (Toll Restriction)
Enable or disable the Outgoing
Disable on Incoming Line feature.
16 Supervise Dial Detection Timer
With the Outgoing Disable on In-
coming Line feature, if dial tone is
not detected after the extension
answers an incoming line, the sys-
tem determines the call is unable
to complete and releases the
DTMF receiver.
17 Restriction Digit in Outgoing
Disable on Incoming Line
With the Outgoing Disable on In-
coming Line feature, determine the
number of digits to be dialed be-
fore the call should be discon-
nected.
18 Reset Dial After Failure of Trunk
Access
Enable (1) or Disable (0) the ability
to continue to dial codes or exten-
sions after receiving Trunk Busy.
This needs to be set to Enabled (1)
for the Forced Trunk Disconnect
feature to work.
2-218
Item Input Data
0 ~ 36
0 ~ 60 seconds
0 = Trunk Access Code
Required
1 = Trunk Access Code
Not Required
0, 1~ 64800 seconds
(0 = Off)
0 ~ 64800 seconds
0 = Disable (Off)
1 = Enable (On)
0 ~ 64800 seconds
Digits 1 ~ 9
0 = Disable (Off)
1 = Enable (On)
Default Related Program
0
10
1
0 11-12-56
20-08-16
3 seconds
0 15-01-05
21-01-16
21-01-17
80-03-01
20 seconds 15-01-05
21-01-16
21-01-17
80-03-01
4 15-01-05
21-01-15
21-01-16
80-03-01
0
Program 21 : Outgoing Call Setup
ISSUE 1.0