Sip System Information Setup - NEC UNIVERGE SV9100 Configuration Manual

Issue 1.0
3.5
12

SIP System Information Setup

Values shown are for example purposes only. Your actual values will be
determined by your implementation team.
Figure 7 SIP System Information Setup
10-28-1 : SIP System Information Setup – Domain Name
Define the Domain name up to 64 characters. This information is specific to your
market and is provided by your SIP Trunking Service Provider.
When configuring Domain name, the SIP service provider will supply the
.
Proxy/Domain in the following manner - "Host Name" . "Domain Name" . The
characters are normally separated by "." The characters after "." will be in the
Domain Name.
10-28-2 : SIP System Information Setup – Host Name
Define the Host name, up to 48 characters.
When configuring Host name, the SIP service provider will supply the Proxy/Domain in
.
the following manner - "Host Name" . "Domain Name" . The characters are normally
separated by "." The characters before "." will be in the Domain Name.
10-28-3 : SIP System Information Setup – Transport Protocol
Define the Transport type. This option is always set to 0 (UDP).
10-28-5 : SIP System Information Setup – Domain Assignment
Determine the type of Domain Assignment. Set this entry to 1 (Domain Name).
10-28-6 : SIP System Information Setup – IP Trunk Port Binding
Set this entry to 0 (Disable) to allow an incoming call to use the lowest port.
SIP Trunking Service Configuration Guide
IDT/Net2Phone