Internal Paging Group Settings - NEC SL1000 Programming Manual

ISSUE 1.0
Level
IN
Description
Use Program 31-03 : Internal Paging Group Settings to assign names to Internal Paging Groups
(i.e., Page Zones) and to define the splash tone for Internal Paging.
The system shows the names you program on the telephone display. Use the following chart when
entering and editing text. When using the keypad digits, press the key once for the first character, twice
for the second character, etc. For example, to enter a C, press 2 three times. Press 2 six times to dis-
play the lower case letter.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ...
1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back
Flash
Input Data
Internal Paging Group Number
Item No. Item
01 Internal Paging Group Name
Assign name to Internal Paging
Groups (i.e., Page Zones). The
system shows the name you pro-
gram on the telephone display.
02 Internal Paging Splash tone type
Allow an extension to have normal
(0), muted (1) or no (2) Internal
Paging alert beeps before a Paging
announcement.
Programming Manual
Program 31 : Paging Setup

31-03 : Internal Paging Group Settings

Key for Entering Names
Enter characters : 1 @ [ ¥ ] ^ _ ` { | }
Enter characters : A-C, a-c, 2.
Enter characters : D-F, d-f, 3.
Enter characters : G-I, g-i, 4.
Enter characters : J-L, j-l, 5.
Enter characters : M-O, m-o, 6.
Enter characters : P-S, p-s, 7.
Enter characters : T-V, t-v, 8.
Enter characters : W-Z, w-z, 9.
Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters : + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
# = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow soft key instead
to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Input Data
Up to 12 Characters
0 = Ordinary volume
1 = Mute
2 = No tone
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
01 ~ 32
Default
Refer to default table.
0
SL1000/SL1100
Program
31
Note
2-319