NEC SL1000 Programming Manual page 403

ISSUE 1.0
Item No.
07 Digital Pager Callback Number
(Pager CBack)
Use this option to set the Digital Pager Callback
Number portion of the Message Notification callout
number for a digital pager. This is the portion of the
callout number that is appended to the pager ser-
vice telephone number. Normally, this option
should be X M#, where:
*
• X is the number of the extension that gener-
ated the notification.
• is a visual delimiter (to make the pager dis-
*
play easier to read).
• M is the number of new messages in the ex-
tension mailbox.
• # is the digit normally used by the pager ser-
vice for positive disconnect.
08 Delay in Dialing Digital Pager Callback Number
(Pager Dial Delay)
Use this option to set the delay (0 ~ 99 seconds)
that occurs just before InMail dials the Digital
Pager Callback Number portion of the Message
Notification callout number for a digital pager.
Set this delay so the pager service has enough
time to connect to the digital pager before sending
the callback number.
Your pager service may be able to help you deter-
mine the best value for this option (0 ~ 99 sec-
onds).
By default, this option is 9 seconds. When placing
a digital pager notification, the system: Seizes the
trunk specified. Dials the user-entered notification
number (in Message + OP + N).
Waits the 47-01-08: Delay in Dialing Digital
Pager Callback Number interval.
Dials the number entered in 47-01-07: Digital
Pager Callback Number.
The system assumes that the notification number
completes dialing approximately 4 seconds after
trunk seizure. This means that, by default, the Digi-
tal Pager Callback Number is dialed into the pager
service about 13 seconds after trunk seizure.
09 Wait Between Digital Pager Callout Attempts
(Notify Pager Intvl)
Use this option to set the minimum time (1 ~ 255
minutes) between unacknowledged or unanswered
digital pager Message Notification callouts. (A sub-
scriber acknowledges a digital pager notification by
logging onto their mailbox.)
After this time expires, InMail tries the callout again
(for up to the number of times set in 47-01-14:
Number of Callout Attempts).
If the system dials the callout number and the
pager service is busy, it retries the number in one
minute.
10 Wait Between Non-Pager Callout Attempts
(Notify N-Pgr Intvl)
Use this option to set the minimum time (1 ~ 255
minutes) between non-pager Message Notification
callouts in which the destination answers, says
Hello, dials 1 to acknowledge and then enters the
wrong security code.
11 Wait Between Busy Non-Pager Callout At-
tempts
(Notify Busy Intvl)
Use this option to set how long InMail waits (1 ~
255 minutes) after it dials a busy non-pager callout
destination, before retrying the callout number.
Programming Manual
Item
Digits
(12 maximum, using 0 ~ 9, #
and
M (Number of messages - en-
tered by pressing LK1)
X (Extension number - entered
by pressing LK2)
InMail automatically replaces the
X command with the number of
the extension that initially re-
ceived the message.
0 ~ 99 seconds
1 ~ 255 minutes
1 ~ 255 minutes
1 ~ 255 minutes
Input Data
)
*
SL1000/SL1100
Default
X M#
*
Program
47
30 seconds
15 minutes
20 minutes
15 minutes
2-381