NEC SL1000 Programming Manual page 362

SL1000/SL1100
Item
No.
04 Route Table Setup of Target
Dial
The option sets how the system
uses the route data (gathered
in Item 3) to route incoming
ANI/DNIS calls.
If option 2 is selected, and the
call is to be routed using the
DID table (1), up to eight digits
can be matched. The number
of expected digits set in Pro-
Program
gram 22-09-01 must match the
ANI digits defined in Program
22-11-01. For example, if an
34
ANI/ DNIS number received
was
2035551234
*
Program 22-09- 01 = 4, the
entry in 22-11-01 must be 1234
with the defined target exten-
sion.
If the call is to be routed using
the ABB table (0), up to 36 dig-
its can be matched. Define the
range of the ABB table to be
used in Program 34-09-06. The
data is compared to the entries
in Program 13-04-01 and then
routed according to Program
13-04-03.
05 ANI/DNIS Display as Target
Dial Name
Use this option to set whether
or not ANI data should appear
on telephone displays as part
of Caller ID display.
06 Routing SPD Table Setup
Use this option to define which
part of the ABB Table set up in
Program 13-04 the system
uses for ANI/DNIS Caller ID
look-ups and ANI/DNIS routing.
This is required if Items 4 and 5
above are 1 (Caller ID on).
When you specify a starting
and end address, the system
uses the part of the table for
look-ups.
When you specify a starting
address and length, the system
uses that part of the table for
routing. If the incoming ANI/
DNIS number data matches the
Number entry in the table, the
system routes according to the
associated Name data. That
data can be an extension, De-
partment Group pilot number,
the voice mail master number
or a trunk ring group.
07 Routing on ANI/DNIS Error
This option lets you determine
how the system handles an
ANI/DNIS call if a data error is
detected in the incoming data
string.
08 Routing When Destination
Busy or No Answer
This option lets you determine
how the system handles an
ANI/DNIS call if destination is
busy or does not answer.
2-340
Item Input Data
0 = SPD Table
(Program 13-03)
1 = DID Table
(Program 22-11)
3001 and
* *
0 = Display Off
1 = Display On
Start = 0, 100 ~ 900
End = 0, 99 ~ 999
0 = Play Busy Tone to
Caller
1 = Route Caller to Ring
Group Specified in Pro-
gram 25-03 (Transfer)
0 = Play Busy or Ringback
Tone to Caller (Busy/
NoAns)
1 = Route Caller to Ring
Group Specified in Pro-
gram 25-04 (Transfer)
Default Default
COS 01 COS 02 ~ 15
0 0
1 0
Start = 900 Start = 0
End = 999 End = 0
1 0
0 0
Program 34 : Tie Line Setup
ISSUE 1.0
Related
Program
13-04
22-11-03
34-09-05
13-04
20-09-02
22-11-03
23-09-04
13-04
25-03
25-04