Single Line Telephone Basic Data Setup - NEC SL1000 Programming Manual

SL1000/SL1100
Level
IN
Description
Program
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various single line tele-
phone options.
15
Input Data
Item
No.
01 SLT Signaling Type
Use this option to tell the system the
type of dialing the connected tele-
phone uses.
For Analog Wireless telephones to
function correctly, this must be set to
0 (dial pulse). If this option is set for
DTMF, after an outside call is
placed, the system cannot dial any
additional digits.
This program change is automati-
cally performed when the Analog
Wireless telephone is registered.
When upgrading software from prior
versions, the previous default of 1 is
saved from the prior database so
this option must be changed manu-
ally.
03 Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
04 Flashing
Enables/disables Flash for single
line telephones.
05 Trunk Polarity Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
06 Extension Polarity Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
07 Enabled On-Hook When Holding
(SLT)
08 Answer On-Hook when Holding
(SLT)
2-124
Program 15 : Extension, Basic Setup

15-03 : Single Line Telephone Basic Data Setup

Extension Number
Item
0 = DP
1 = DTMF
0 = Normal
1 = Special
0 = No
1 = Yes
0 = Off
1 = On
0 = Disable (Off)
1 = Enable (On)
0 = No
1 = Yes
0 = Disable (No)
1 = Yes (Enable)
Maximum four digits (SL1000)
Maximum eight digits (SL1100)
Input Data Default
1
0
1
0
0
1
1
Program 15 : Extension, Basic Setup
ISSUE 1.0
Related Pro-
Note
gram
15-03-03
45-01-01
15-03-01
45-01-01
11-12-45
11-12-46