NEC SL1000 Programming Manual page 121

ISSUE 1.0
Item
Item
No.
21 Caller ID Block Code
Enter the code, up to 8 digits,
that should be used as the Caller
ID Block Code. This code is au-
tomatically inserted before dialed
digits if Program 14-01-20 is set
to 1.
22 Caller ID to Voice Mail
Enable or disable the system
ability to send the Caller ID digits
(Remote Log-On Protocol) to
voice mail.
23 Least Cost Routing
24 Trunk-to-Trunk Outgoing
Caller ID through Mode
Enable (1) or Disable (0) the
ability to send the original Caller
ID through when the call is For-
ward Off-Premise.
25 Continued/Discontinued
Trunk-to-Trunk Conversation
Enable (1) or Disable (0) the
ability to dial a service code to
continue or disconnect the
Trunk-to-Trunk conversation
after the alert tone is heard.
26 Automatic Trunk-to-Trunk
Transfer Mode
27 Caller ID Refuse Setup
28 Effectively of "Conversation
Recording Destination for
Extension"
30 Flexible Ringing by Caller ID
32 Anti-trombone Function
33 APSU(VM00) Trunk Receive
Gain
Additional PAD when a trunk call
connects to APSU Voice Mail.
Default
Item01 : Trunk Name
Trunk Port Number
1
2
:
126 (SL1000)
96 (SL1100)
Programming Manual
Input Data Default
Dial (up to eight dig- No setting
its)
0 = Disable (No) 0
1 = Enable (Yes)
0 = LCR Off 0
1 = LCR On
2 = LCR On (Cost
Center Code only)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Normal Transfer 0
(Normal)
1 = Step Transfer
(Step)
0 = Disable (No) 0
1 = Enable (Yes)
0 = No Effect (No) 1
1 = Available (Yes)
0 = Disable (No) 1
1 = Enable (Yes)
0 = No Effect (No) 0
1 = Available (Yes)
1 ~ 63 32 (0 dB)
(- 15.5 dB ~ + 15.5
dB in 0.5 dB inter-
vals)
SL1000/SL1100
Related Program
Note
14-01-20
20-08-15
20-28-01
20-28-02
20-28-03
24-02-07
24-02-10
25-07-07
25-07-08
24-02-11
24-02-12
15-12
13-04
Name
Line 001
Line 002
:
Line 126 (SL1000)
Line 96 (SL1100)
Program
14
2-99