Did Translation Number Conversion - NEC SL1000 Programming Manual

ISSUE 1.0
Level
SA
Description
Use Program 22-11 : DID Translation Number Conversion to specify for each Translation Table
entry (800).
• The digits received by the system (eight maximum)
• The extension the system dials after translation (36 digits maximum)
• The name that should show on the dialed extension display when it rings (12 characters maximum)
• The Transfer Target - 1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer destina-
tion (Program 22-10).
• Operation Mode
Use the following chart when entering and editing text for names. Press the key once for the first char-
acter, twice for the second character, etc. For example, to enter a C, press 2 three times.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ...
1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back
Flash
Input Data
Conversion Table Number
Item No. Input Data
01 Received Number
This is the received DID digits.
Programming Manual
Program 22 : Incoming Call Setup

22-11 : DID Translation Number Conversion

Key for Entering Names
Enter characters: 1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Enter characters: T-V, t-v, 8.
Enter characters: W-Z, w-z, 9.
Enter characters: 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters: + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right
arrow soft key instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Maximum eight digits
(0 ~ 9, , #, @)
*
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
001 ~ 800
Description
SL1000/SL1100
Program
22
Default
See Default Value
2-255