Ardf Output Check (Sp6-008); Finisher Output Check (Sp6-118); Tray Lift - Ricoh U-C1 B051 Service Manual

26 July 2002

ARDF Output Check (SP6-008)

1. Open SP6-008.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table below.)
3. Touch ON to test the selected item. To end the test, touch OFF. You cannot
exit and close this display until you touch OFF to switch off the output check
currently executing.
No.
1 Feed Motor (Forward)
2 Feed Motor (Reverse)
3 Transport Motor (Forward)
4 Feed Clutch
5 Pick-up Solenoid
6 Junction Gate Solenoid
7 Stamp Solenoid

Finisher Output Check (SP6-118)

1. Open SP6-118.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table below.)
3. Touch ON to test the selected item. To end the test, touch OFF. You cannot
exit and close this display until you touch OFF to switch off the output check
currently executing.
No.
1000-sheet finisher
1 Fin All Off
2 Upper Transfer Motor
3 Lower Transfer Motor
4 Exit Motor
5 Tray Gate Sol
6 Tray Lift Motor
7 Jogger Motor
12 Stapler Motor
13 Staple Hummer
15 Stapler Gate Sol
16 Pos. Roller Sol
18 Feed-out Motor
19 Shift Motor
22 Guide Plate Motor
23 Fin Free Run 1
24 Fin Free Run 2
Description
Description
5-73
Description
No.
500-sheet finisher
101 500 Fin All Off
102 500 Fin Main Motor
103 500 Fin Jogger Motor
104 500 Fin Paddle Sol
105 500 Fin Gear Sol
106 500 Fin Lever Sol
107 500 Fin Tray Motor
108 500 Fin Stapler Motor
109 500 Fin Free Run 1
110 500 Fin Free Run 2
DUMMY