Sp Mode 9-Output Check - Ricoh Robin Service Manual

SERVICE PROGRAM MODE
2.4 SP MODE 9–OUTPUT CHECK
– How to turn electrical components on/off –
1. Enter "9" by the numeral key, then press the Auto Image Density key.
2. Enter the desired number given in the following table.
3. Press the Start key to turn on the electrical component.
4. Press the Clear/Stop key to turn off the electrical component.
Number
1 Main Motor + Quenching Lamp
2 Charge Corona + Standard Image Grid
3 Charge Corona + Standard ID Sensor Grid
4 Charge Corona + Standard Vrp Grid
5 Transfer Corona
6 Separation Corona
8 Erase Lamp
9 ID Sensor LED
11 Toner Supply Clutch + Main Motor
12 Registration Clutch
13 1st Paper Feed Clutch
15 Relay Roller Clutch
18 Exhaust Blower Motor
19 Optics Cooling Fan (A152 copier only)
20 Exposure Lamp + Optics Cooling Fan (A152 copier only)
22 Charge Corona + Image Grid with correction + Transfer Corona + Separation
Corona
23 Charge Corona + ID Sensor Grid with correction + Transfer Corona +
Separation Corona
24 Charge Corona + Vrp Grid with correction + Transfer Corona + Separation
Corona
25 Charge Corona + Image Grid with correction
26 Charge Corona + ID Sensor Grid with correction
27 Charge Corona + Vrp Grid with correction
30–37 Development Bias Voltage in 40 volts steps starting at –120 volts
38 Development Bias Voltage = –500 volts
40–48 Grid Voltage in 60 volts steps starting at –400 volts
Electrical Component
4-22
24 June 1994