Abort Control Procedure - RADWAG 3Y Series User Manual

Press START
•
window. Program shall proceed to the main window of product control, used
for entering data.
Caution:
If before control:
Load has not been removed from the weighing pan or if other requirements
•
for zeroing have not been fulfilled (e.g. unstable indication), than message
<-Err 2> shall be displayed. Upon noticing <-Err 2> message the user shall
unload the balance and wait until all zeroing requirements are met,
The user has not logged in or is logged but has not got the right access to
•
perform control, than <No authority/Access denied> message shall be
displayed,
The user has not selected product out of database than <Product not
•
chosen> message shall be displayed.

27.7. Abort control procedure

The user may abort procedure being in progress at any chosen moment, to do it
button (abort control) must be pressed. The button is located in bottom
part of the window.
Upon pressing the button
displayed
To abort control the user must press button
setting window of PGC mode. Control report with status <Aborted> is saved to
< Controls> database.
To proceed with the control the user must press button
located in a bottom part of a parameters settings
(abort control) the following message is
- 143 -
, the program gets back to a
.