Table of Contents
Advertisement
Single part mass value must be equal or greater than 0.1
of the reading unit. Unless this condition is met,
the weighing device displays a message <Err Lo>.
In the course of parts quantity determination before
confirming the declared quantity value it is necessary to wait
for a stable measurement,
22. WORKING MODE – +/- CONTROL
+/- control is a working mode enabling you to enter checkweighing thresholds
values (Min, Max).
22.1. Local Settings
To go to local settings enter <3.3.HiLo> submenu.
3.3.1.Acc
Working mode accessibility
3.3.2.Snn
Save mode
3.3.3.Int
Time interval
3.3.4.Lo
Lo threshold
22.2. Declaring Checkweighing Thresholds
Enter <HiLo> working mode (+/- control), first, text <SEt Lo> is displayed
for 1 s, next, window for declaring low weighing threshold (Min).
Enter respective value and press
is displayed for 1 second, next, window for declaring high weighing
threshold (Max).
Enter respective value and press
mode's home screen is displayed along with declared threshold value,
where:
Min
Load mass lower than low weighing threshold.
Ok
Load mass within weighing thresholds.
Max
Load mass greater than high weighing threshold.
If the entered low threshold value (Min) is greater than high
threshold value (Max), <Err Lo> error is displayed.
.
For detailed description read section 19.2.1.
For detailed description read section 19.2.2.
For detailed description read section 19.2.3.
For detailed description read section 19.2.4.
key to confirm, first, text <SEt Hi>
key for confirmation, working
38
Advertisement
Table of Contents
