Dosing Function In Parts Counting Mode - RADWAG 3Y Series User Manual

Procedure
Press grey coloured workspace and press option <Information>
•
Set Bargraph option to YES, return to parts counting mode
•
Press grey coloured workspace and press option <Keys>
•
Assign <Checkweighing thresholds> option to one of the quick access keys
•
displayed in the bottom bar
Return to parts counting mode
•
Press < Checkweighing thresholds> key and insert values for LOW and
•
HIGH thresholds, return to parts counting mode
Under the measurement result there is bargraph displayed. Colour of the
•
bargraph corresponds to the status of parts counting process.
Yellow bargraph's colour: current number of parts below set value of
o
Low threshold
Green bargraph's colour: current number of parts within set value of
o
thresholds
Red bargraph's colour: current number of parts above set value of High
o
threshold

16.9. Dosing function in parts counting mode

Parts counting process can be aided by dosing function, i.e. control whether
indication does not exceed set target value.
Dosing requires setting a value, which is the target, for instance 100 parts,
and percent tolerance from the target value. The target value is displayed as a
bracket on a bargraph.
Defining the value of target mass is carried out using a quick access key
< Target Value>.
Procedure
Press grey coloured workspace and press option <Information>
•
Set Bargraph option to YES, return to parts counting mode
•
Press grey coloured workspace and press option <Keys>
•
Assign <Target Value> option to one of the quick access keys displayed in
•
the bottom bar
Return to parts counting mode
•
- 71 -