Adapter Parameters - IBM F80 Service Manual

Adapter Parameters

Select the Adapter Parameters option from the Network Parameters menu to view an
adapter's hardware address, as well as configure network adapters that require setup. A
screen similar to the following displays when you make this selection:
Adapter Parameters
Device
1. Gigabit Ethernet
2. token-ring
3. ethernet Integrated:P1/E1
4. ethernet
5. token-ring
(PRESS ENTER AFTER MAKING A SELECTION) ===>
Select an adapter on this screen to display configuration menus for that adapter. If
ethernet is selected, you can set parameters that control how the ethernet adapter
communicates with the network. For example, the following screen shows the menu for
the ethernet adapter configuration:
1. Data Rate [Auto]
2. Full Duplex [No]
Slot Hardware Address
4: P1-I4/E1 0004ac7c0135
5: P1-I5/T1 0020357a9105
0060949d7ac5
2: P1-I2/E1 0004ac5e692b
3: P1-I3/T1 0004ac634e38
.------.
|X=Exit|
`------'
Chapter 8. Using System Management Services
301