Wireless Settings - GeoVision GV-Compact DVR V2 User Manual

4.7.3 Wireless Settings

To use the wireless function, a wireless LAN USB Adaptor is required. For supported wireless
LAN adaptors, see Appendix A.
NETWORK TYPE: Select AD HOC or INFRASTRUCTURE for the network mode.
AD HOC: A Peer-to-Peer mode. This mode connects to other computer with the
WLAN card, and does not need the Access Point to connect to each other.
INFRASTRUCTURE: Via the Access Point to connect to the Internet. This mode
further gives wireless access to the Internet or data sharing under a previously wired
environment.
ACCESS POINT SURVEY: Search all the available Access Points (Infrastructure mode)
and wireless stations (AD-Hoc mode) within the range of your WLAN card.
NAME (SSID): The SSID (Service Set Identity) is a unique name that identifies a particular
wireless network. Enter SSID of the Wireless LAN group or Access Point you are going to
connect to.
AUTH. TYPE: Select one of these network authentication and data encryption: DISABLE,
WEP, WPASPSK-AES, WPA2PSK-TKIP or WPA2PSK-AES.
WEP: Abbreviated for Wired Equivalent Privacy, this is a type of data encryption.
Type up to 4 WEP keys in HEX or ASCII format. Note that if you use HEX format, only
digits 0-9, letters A-F and a-f are valid.
WPASPSK-AES or WPA2PSK-AES: Type WPA-PSK (Pre-Shared Key) for data
encryption.
WPA2PSK-TKIP: Type WPA-PSK (Pre-Shared Key) for data encryption.
Note: Your encryption settings must match those used by the Access Points or wireless
stations with which you want to associate.
62
Figure 4-34