Wireless Settings - GeoVision GV-LX4C3D1 User Manual

4.7.3 Wireless Settings

To use the wireless function, a wireless LAN USB Adaptor is required. For supported wireless
LAN adaptors, see Appendix A.
NETWORK TYPE: Select AD HOC or INFRASTRUCTURE for the network mode.
AD HOC: A Peer-to-Peer mode. This mode connects to other computer with the
WLAN card, and does not need the Access Point to connect to each other.
INFRASTRUCTURE: Via the Access Point to connect to the Internet. This mode
further gives wireless access to the Internet or data sharing under a previously wired
environment.
ACCESS POINT SURVEY: Search all the available Access Points (Infrastructure mode)
and wireless stations (AD-Hoc mode) within the range of your WLAN card.
NAME (SSID): The SSID (Service Set Identity) is a unique name that identifies a particular
wireless network. Enter SSID of the Wireless LAN group or Access Point you are going to
connect to.
AUTH. TYPE: Select one of these network authentication and data encryption: DISABLE,
WEP, WPASPSK-AES, WPA2PSK-TKIP or WPA2PSK-AES.
WEP: Abbreviated for Wired Equivalent Privacy, this is a type of data encryption.
Type up to 4 WEP keys in HEX or ASCII format. Note that if you use HEX format, only
digits 0-9, letters A-F and a-f are valid.
WPASPSK-AES or WPA2PSK-AES: Type WPA-PSK (Pre-Shared Key) for data
encryption.
WPA2PSK-TKIP: Type WPA-PSK (Pre-Shared Key) for data encryption.
Note:
1. Your encryption settings must match those used by the Access Points or wireless
stations with which you want to associate.
2. When you lose the wireless access, you can still access the unit by connecting it to a
LAN and logging in with the default IP address 192.168.0.10.
84
Figure 4-35