Digital Io Settings; Digital Input Settings - GeoVision GV-Compact DVR V2 User Manual

4.2 Digital IO Settings

The I/O terminal block, on the rear panel of the GV-Compact DVR V2, provides the interface
for the applications of digital input, relay output and GPS.

4.2.1 Digital Input Settings

The GV-Compact DVR V2 can connect up to 4 input devices. To select one input device for
setup, press the desired Channel button on the Remote Control.
STATE: Enable the selected input.
NAME: Enter a descriptive name for the input device.
NORMAL STATE: Set the input state to OPEN CIRCUIT (normally open) or GROUNDED
CIRCUIT (normally closed).
LATCH MODE: Enable this mode to have a momentary output alarm.
TRIGGER RELAY: Select the output(s) to be triggered once the input is activated.
RECORD: Select the camera(s) to start recording once the input is activated.
CV2 Alert: Select the camera(s) to send their images to Center V2 when the input is
triggered.
Also see 6.2.1 I/O Control of the Web-based configuration which provides more information
and features of the digital input settings.
42
Figure 4-14