Connecting To The Vehicle - GeoVision GV-Compact DVR V2 User Manual

3.3.2 Connecting to the Vehicle

You need to connect the Anti-Vibration Model of ACC Version to ACC wire and power wire on
the vehicle. When the unit is connected to the ACC wire properly, it will automatically start
after you power on the vehicle for 5 seconds. After you power off the vehicle for 30 seconds,
the unit will turn off automatically. During the 30 seconds after power off, the GV-Compact
DVR V2 will stop recording and the hard drive will be removed from the system automatically.
IMPORTANT:
1. Switch the ignition off before proceeding.
2. Below is an example of how to connect the Anti-Vibration Model of ACC Version to the
vehicle. Since each vehicle differs in design, refer to the owner's manual of your vehicle
for details and carefully follow the safety measures. If you are unsure about how to carry
out the instructions, have the installation done by a properly trained technician.
18
Figure 3-4