Cursor And Menu Selection Speed; Changing The Ships Icon - Standard Horizon CP1000C Owner's Manual

To change from Cursor Mode to Home Mode press [CLEAR].
Home mode
When the ships icon is only shown on the Chart page (cursor is not shown) you are in
home mode. Now as the ship moves through the water the vessels position will be kept in
the center of the display.
3.1.2

Cursor and Menu selection speed

The chartplotter allows you to control the speed the Cursor moves when the ShuttlePoint
knob is pressed. To change the speed:
1. Press [MENU]. Move the ShuttlePoint knob to SETUP and either press [ENTER] or
move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to CURSOR SPEED and press [ENTER] or move the
ShuttlePoint key to the right.
3. The menu now shows two selections, CHART and MENU which allows the cursor speed
to be selected to High, Medium or low on Chart page or within the menus.
4. With CHART or MENU selected press [ENTER] or move the ShuttlePoint knob to the
right. Move the ShuttlePoint knob to the desired setting and press [ENTER] or move the
ShuttlePoint knob to the right.
5. Press [CLEAR] until the menu disappears or an easier method is to press the
Shuttlepoint knob to the left a few times.
6. Move the cursor on the Chart page and see if the speed is to your liking.
3.1.3

Changing the Ships Icon

The cursor may be changed to any of the following:
Page 28
NOTE
Figure 3.1.2 - Cursor Speed menu
Figure 3.1.3 - Ships icons
GPS chartplotters