Usb Id Input; Installation Procedure For Program; Procedure For Program Operation - Epson AcuLaser C4000 Service Manual

EPSON AcuLaser C4000/C4100/C3000

5.1 USB ID Input

AcuLaser-C4000 comes with the USB inter face as standard, and the
PC connected to the AcuLaser-C4000 via the USB interface identifies
the printer by referring to the USB ID information specific to each
printer.
Since this USB ID information is stored on EEPROM on the MAIN
Board of the printer, you have to re-define the ID information by the
procedure described below when you have replaced the MAIN Board
for repair.
When you repair the printer and re-define the USB ID
C A U T I O N
information, you have to tell the user to uninstall the
previously installed printer driver as it is referring to
the old USB ID information.
The program for USB ID input and the supported operating environment
are as follows:
Program
EJL BasePagePrinter_14.exe
Operating environment
OS: Windows95 OSR 2.0 or later or Windows98
Port used: LPT1 - LPT3 (Windows95/98)
Adjustment

5.1.1 Installation Procedure for Program

Copy the adjustment program file (EJL BasePagePrinter_14.exe) onto
the desk top or into a folder.

5.1.2 Procedure for program operation

DO not start the adjustment program before
C A U T I O N
connecting the parallel cable to the printer.
This program can not be executed together with EPW
(EPSON Printer Window) on Windows 95/98. Be sure
to terminate the EPW before starting the adjustment
program.
If the power to the printer is turned off or the parallel
cable is disconnected during running of the
adjustment program, be sure to restart the program.
On the "Details of Display" tab of "Property of
Screen", do not change "font size".
1. When you execute the program "EJL BasePagePrinter_14.exe", the
menu window shown Figure 5-1 will apper.
2. Select the model name "AL-C4000", then click "OK" button.
Figure 5-1. Program start up window
USB ID Input
Revision F
5-458