Epson AcuLaser C4000 Service Manual page 384

EPSON AcuLaser C4000/C4100/C3000
4.2.10.6 ELIMINATOR ASSY (PL7.1.9) Removal
1. Remove the COVER ASSY FRONT HEAD. (See Section 4.2.4.2.)
2. Remove the 1 screw securing the ELIMINATOR ASSY to the CHUTE
ASSY OUT (PL7.1.1).
3. After lifting the left end of the ELIMINATOR ASSY rearwards away from
the CHUTE ASSY OUT, remove the ELIMINATOR ASSY by pulling it out
to the left.
Figure 4-64. ELIMINATOR ASSY (PL7.1.9) Removal
Disassembly and Assembly
4.2.10.7 ROLL DUP (PL7.1.12) Removal
1. Remove the FUSER ASSY. (See Section 4.2.12.1.)
2. Remove the COVER ASSY FRONT HEAD. (See Section 4.2.4.2.)
3. Remove the COVER MSI. (See Section 4.2.4.11.)
4. Remove the TRAY ASSY MSI. (See Section 4.2.4.12.)
5. Remove the COVER ASSY FRONT IN. (See Section 4.2.4.13.)
6. Release the 1 hook of GEAR 30 (PL7.1.10) secured to upper shaft of the
ROLL DUP from the CHUTE ASSY OUT of the printer body.
7. Remove the GEAR 30 from the shaft of ROLL DUP.
8. Remove the BEARING EARTH (PL7.1.11) securing the left side shaft of
the ROLL DUP to the CHUTE ASSY OUT.
9. Remove the E-ring securing the right side shaft of the ROLL DUP to the
CHUTE ASSY OUT.
10. Remove the BEARING (PL7.1.16) securing the right side shaft of the
ROLL DUP to the CHUTE ASSY OUT.
11. Lift the right side of the ROLL DUP shaft upward and away from the
CHUTE ASSY OUT, free it from the shaft socket, then remove the ROLL
DUP.
Disassembly Assembly Procedures
Figure 4-65. ROLL DUP (PL7.1.12) Removal
Revision F
4-369