Epson AcuLaser C4000 Service Manual page 408

EPSON AcuLaser C4000/C4100/C3000
4.2.15.4 HOLDER TONER ASSY (C) (PL12.2.3) Removal
1. Remove the COVER ASSY TOP MAIN. (See Section 4.2.4.4.)
2. Remove the COVER SIDE L. (See Section 4.2.4.14.)
3. Remove the COVER SIDE R. (See Section 4.2.4.9.)
4. Remove the HOLDER TCRU ASSY UNIT. (See Section 4.2.15.1.)
5. Remove the HOLDER TONER ASSY (K). (See Section 4.2.15.5.)
6. From the HOLDER TCRU ASSY UNIT, use a small screwdriver to release
the hook securing the toner emitter of the HOLDER TONER ASSY (C) to
the PLATE ASSY DISPENSER (PL12.3.1).
7. Pull out the toner emitter on the HOLDER TONER ASSY (C) to the right
from the PLATE ASSY DISPENSER.
8. Pull out the connector (P/J513) of the motor from the right side of the
HOLDER TONER ASSY.
In the following step, the HOLDER TCRU ASSY UNIT and
C A U T I O N
the HOLDER TONER ASSY (C) are kept connected to the
printer body with a harness. Therefore, does not move too
far.
9. Release the hook fixing the HOLDER TONER ASSY (C) to the PLATE
ASSY DISPENSER, slide it to the right side and release the motor side
hook, shift the motor side toward the rear and open a gap between it and
the HOLDER TONER ASSY (M).
10. Pull out the connectors (P/J443, P/J433) from the HOLDER TONER ASSY
(C).
11. Free the HARNESS ASSY TNR (PL12.1.6) from the hook on the HOLDER
TONER ASSY (C) and remove the HOLDER TONER ASSY (C).
Be sure to attach the hook of motor side.
Disassembly and Assembly
Figure 4-91. HOLDER TONER ASSY (C) (PL12.2.3) Removal
Disassembly Assembly Procedures
Revision F
4-393