Epson AcuLaser C4000 Service Manual page 373

EPSON AcuLaser C4000/C4100/C3000
4.2.8.2 ROLL TURN (PL5.1.2) Removal
1. Pull out the CHUTE ASSY REGI. (See Section 4.2.13.1.)
2. Remove the HOUSING ASSY RETARD. (See Section 4.2.8.1.)
3. Remove the CLUTCH TURN MSI. (See Section 4.2.8.4.)
4. Remove the E-ring securing the left side of the ROLL TURN to the
HOUSING ASSY RETARD (PL5.1.1).
5. Remove the BEARING EARTH (PL5.1.13) securing the shaft at the left
side of the ROLL TURN from the HOUSING ASSY RETARD.
6. Remove the BEARING RUBBER R (PL5.1.13) set on the shaft at the right
side of the ROLL TURN from the HOUSING ASSY RETARD.
7. From the HOUSING ASSY RETARD, let the ROLL TURN slide to the right,
remove the shaft on the left side of the ROLL TURN from the shaft socket
hole, then remove the ROLL TURN upward and to the left.
Disassembly and Assembly Disassembly Assembly Procedures
Figure 4-46. ROLL TURN (PL5.1.2) Removal
Revision F
4-357