Epson AcuLaser C4000 Service Manual page 406

EPSON AcuLaser C4000/C4100/C3000
4.2.15.2 HOLDER TONER ASSY (Y) (PL12.2.1) Removal
1. Remove the COVER ASSY TOP MAIN. (See Section 4.2.4.4.)
2. Remove the COVER SIDE L. (See Section 4.2.4.14.)
3. Remove the COVER SIDE R. (See Section 4.2.4.9.)
4. Remove the HOLDER TCRU ASSY UNIT. (See Section 4.2.15.1.)
5. Remove the HOLDER TONER ASSY (K). (See Section 4.2.15.5.)
6. Remove the HOLDER TONER ASSY (C). (See Section 4.2.15.4.)
7. Remove the HOLDER TONER ASSY (M). (See Section 4.2.15.3.)
8. From the HOLDER TCRU ASSY UNIT, use a small screwdriver to release
the hook securing the toner emitter of the HOLDER TONER ASSY (Y) to
the PLATE ASSY DISPENSER (PL12.3.1).
9. Pull out the toner emitter on the HOLDER TONER ASSY (Y) to the right
from the PLATE ASSY DISPENSER.
10. Pull out the connector (P/J511) of the motor from the right side of the
HOLDER TONER ASSY (Y).
11. Pull out the connectors (P/J441, P/J431) from the HOLDER TONER ASSY
(Y).
12. Free the HARNESS ASSY TNR (PL12.1.6) from the hook of the HOLDER
TONER ASSY (Y) and then remove it.
13. Release the hook securing the HOLDER TONER ASSY (Y) to the PLATE
ASSY DISPENSER.
14. Slide the HOLDER TONER ASSY (Y) to the right to remove it.
Disassembly and Assembly
Figure 4-89. HOLDER TONER ASSY (Y) (PL12.2.1) Removal
Disassembly Assembly Procedures
Revision F
4-391