Epson AcuLaser C4000 Service Manual page 353

EPSON AcuLaser C4000/C4100/C3000
4.2.7.10 GUIDE INDICATOR (PL4.2.13) Removal
1. Pull out the CASSETTE from the printer body.
2. Remove the COVER ASSY TOP MAIN. (See Section 4.2.4.4.)
3. Remove the COVER SIDE L. (See Section 4.2.4.14.)
4. Remove the COVER SIDE R. (See Section 4.2.4.9.)
5. Remove the COVER CASSETTE REAR. (See Section 4.2.7.2.)
6. Move the shaft socket of the LINK ACTUATOR secured to the ACTUATOR
NO PAPER (PL4.3.6) away from the FEEDER parts, the let the shaft of the
ACTUATOR NO PAPER come free.
7. Pull out the LINK ACTUATOR of the hole of the FEEDER part and remove
it.
8. Disconnect the connector (P/J2361) used to connect the printer body and
the FEEDER ASSY from the left side surface of the printer body.
9. Disconnect the connector (P/J210) that connect the printer body and
FEEDER ASSY from the right side surface of the printer body.
10. Disconnect the connector (P/J47) on the PWB DRIVE (PL15.1.15) from the
right side surface of the printer body.
11. Remove the 8 screws (gold, tapped, 8mm) securing the FEEDER ASSY to
the printer body.
When performing the following step, the 1 screw (L85)
C A U T I O N
(PL4.1.13) at the left side of the FEEDER ASSY can scrape
against the printer body housing as it is being removed,
so it is better to also remove the other 3 long screws and
hold the body parts to the side while removing the
FEEDER ASSY.
When performing the following step, the Washer
(PL4.1.14) can easily fall out, so this may be prevented by
using a punch or other tool to hold the washer while
removing the part or by using a screwdriver with a strong
magnetic tip.
12. Remove the 4 screws (L85) with a washer securing the FEEDER ASSY to
the printer body.
Disassembly and Assembly
Figure 4-34. GUIDE INDICATOR (PL4.2.13) Removal
Disassembly Assembly Procedures
Revision F
4-337