Epson AcuLaser C4000 Service Manual page 427

EPSON AcuLaser C4000/C4100/C3000
4.2.18.7 HOUSING ASSY CONTACT (PL15.1.8) Removal
1. Remove the PWB Controller (PWB ESS). (See Section 4.2.19.1.)
2. Remove the CHUTE ASSY REGI. (See Section 4.2.13.1.)
Be sure that the CHUTE ASSY REGI is removed when
C A U T I O N
performing the following step. If the step is performed with
the CHUTE ASSY REGI installed, it may cause deformation
of the SPRING DRUM EARTH.
3. Remove the COVER ASSY TOP MAIN. (See Section 4.2.4.4.)
4. Remove the COVER SIDE L. (See Section 4.2.4.14.)
5. Remove the HSG ASSY BIAS. (See Section 4.2.14.2.)
Be sure that the HSG ASSY BIAS is removed when
C A U T I O N
performing the following step. If the step is performed with
the HSG ASSY BIAS installed, it may cause deformation of
the HSG ASSY BIAS.
6. Remove the COVER SIDE R. (See Section 4.2.4.9.)
7. Remove the COVER REAR. (See Section 4.2.4.6.)
8. Remove the HOLDER TCRU ASSY UNIT. (See Section 4.2.15.1.)
9. Remove the COVER CASSETTE REAR. (See Section 4.2.7.2.)
10. Remove the BOX ASSY ELEC. (See Section 4.2.18.6.)
11. Remove the 2 screws securing the HOUSING ASSY CONTACT to the
BOX ASSY ELEC (PL15.1.6).
12. Pull out the HOUSING ASSY CCONTACT from the BOX ASSY ELEC, and
remove HOUSING ASSY CCONTACT.
Disassembly and Assembly
Figure 4-113. HOUSING ASSY CONTACT (PL15.1.8) Removal
Disassembly Assembly Procedures
Revision F
4-412